From: Jack
Subject: Contact Form
Message Body:
Good afternoon,
We are looking to use your FD High-V fluid dispenser in conjunction with a UR Robot to apply an RTV to a transmission case for sealing. I see in the FAQ’s the high-V is usually setup between 0.5 and 3 Bar for the inlet material. What is the maximum working pressure of the High-V dispenser? We will have to use a ram mounted pump to feed the system but will also need a pressure fluid regulator to step down the pressure so we are interested in how high we can go? Will we also see material drip with the higher pressure?
Thank you
—
This e-mail was sent from a contact form on Aim Robotics (https://aim-robotics.com)
Request ID: wBituE
Configurator: FD Dispenser
Product: FD Series Material Dispenser